![]() This is most easily done by inserting the ball into the launch chamber with your index finger, guiding the ball into the launch chamber. Insert one steel ball into the launch chamber.Turn clockwise for higher pressure and higher muzzle velocity and counter-clockwise for lower pressure and lower muzzle velocity. Set the release pressure by adjusting the range knob.Loosen the knob on the back of the unit, rotate the launch chamber to the desired launch angle, then secure the knob.Connect the sensor following the steps in the Getting Started section of this user manual.We recommend placing the launcher on a sturdy table and securing the launcher to the table with table clamps (not included). Place the launcher on a flat surface and secure.Powering the Sensorįollow these steps when using the Go Direct Projectile Launcher when performing basic launch experiments. Note: Be sure to always load the ball into the chamber before starting data collection, as your fingers will pass through the arms of the photogates. Launch Graphical Analysis 4 or turn on LabQuest 2. ![]() The LED will blink green when successfully connected. If using Graphical Analysis 4, click or tap Done. Your sensor's ID is located near the barcode on the sensor. Select your Go Direct sensor from the list of Discovered Wireless Devices.If using LabQuest 2, choose Wireless Device Setup ˃ Go Direct from the Sensors menu. If using Graphical Analysis 4, click or tap Sensor Data Collection.Connect your sensor to a USB wall outlet, USB power brick, or available USB port on a device.See for Graphical Analysis 4 availability or to update LabQuest App. If using LabQuest 2, make sure LabQuest App is up to date. Install Graphical Analysis 4 on your computer, Chromebook™, or mobile device. Please see the following link for platform-specific connection information: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |